APRILIA X 250TH

Moto RSV4 1100 Factory 2026 built by Aprilia Racing, non-street legal.

Important 
Warranty: No part of the bike is covered by warranty.
Public roads usage ban: This motorbike and its components has been designed only for race use in closed circuits, therefore it is devoid of registration documents. It is strictly forbidden to use this motorbike on public roads.
All information and technical data here mentioned could be subject to change without notice.

Delivery: To be defined, no earlier than 80 working days after order confirmation.

Condition: EXW Aprilia Racing (Noale, Venice – Italy).

Payment: Bank transfer. 50% at time of order, balance before delivery.

The bike has been modified as follow:

V4 65°, 1099 cc with SBK racing specifications

SC-Project Titanium Full-System Exhaust MotoGP Replica 4x2 with balance pipe between cylinder banks

MY25 throttle body and dedicated intake manifolds

High permeability racing - MotoGP technology - Sprint Filter

APX Aprilia Racing with specific settings and GPS system

Oversized Racing - SBK technology

Titanium rear sprocket and lighter front sprocket by PBR (designed by Aprilia Racing)

Regina Chain 520

240 HP @ 13750 Rpm

131 Nm @ 11750 Rpm

14.100 Rpm

Marchesini in forged Mg M7R GENESI (front 17’’x3.5’’ – rear 17’’x6’’)

Brembo Carbon-Carbon, with carbon discs – 340 mm diameter high mass - MotoGP configuration, carbon brake pads - MotoGP configuration and billet aluminum caliper with cooling fins

Nikel-plated

Öhlins FKR pressurized cartridge with mechanical control. Adjustable in spring preload, hydraulic (with dedicated setup) compression and rebound damping. 
Fork bottoms designed by Aprilia Racing, fully CNC machined, for MotoGP derived brake calipers with 108 mm spacing.

Öhlins TTX mechanically managed piggyback derived from MotoGP, fully adjustable in: spring pre-load, wheelbase and hydraulic compression (with dedicated setup) and rebound damping.

Ohlins, adjustable

Dry clutch by STM

Racing, lighter, CNC machined, with limited edition number

Racing by Jetprime

Racing by Domino

Racing, adjustable, by Spider

MotoGP specifications, full carbon by PAN Compositi

Carbon front and under wing, cornering wings, tail wings, seat wings as from MotoGP, by PAN Compositi

Structural carbon seat support, by PAN Composit

Full carbon

“Stars and Stripes”

Fuel tank cap, engine crankcase and brake lever protection, by Spider

Pirelli Slick Diablo SBK ant. SC-1 125/70 post. SC-X 200/65

165 kg

Yashi laptop, personalized mat and bike cover, titanium rear and front stands by RCB, tyre warmers by IRC

Total EUR 115,000.00
VAT excluded (EXW Noale)

Only for US Market
MSRP 150.000 USD

Download technical sheet

-thumb
-thumb
-thumb
-thumb
-thumb

See also